Ponte posteriore Jeep JK rinforzato
– Facile installazione
– High Pinion con struttura centrale rinforzata
– Verniciatura speciale anti-corrosione
– 2X più resistente rispetto al Dana44 originale
– Seamiassi Currie Chromoly 4340
Il Ponte posteriore Jeep JK rinforzato Currie Dana 44 è stato progettato per l’off-road, offre leggerezza e massima robustezza, testato per supportare pneumatici maggiorati fino alle 37″.
Ponte posteriore Jeep JK rinforzato
Ponte posteriore Jeep JK rinforzato
SCHEDA TECNICA:
Vehicle Fitment | Currie 44 low-pinion nodular-iron center section with thicker walls and webbing |
Gear Set | Larger/stronger JK Dana 44™ 8.8” late model ring and pinion set |
Pinion Yoke | 1350 u-joint |
Differential Cover | Currie nodular-iron cover with gasketed fill plug with dipstick, Red |
Axle Tubes | 3 inch diameter, .375 wall DOM tube |
Axle Bearings | Set 10 tapered roller bearing |
Axles | Currie Performance semi-floating 30-spline 4140 chromoly axles with JK tone rings installed for ABS and ESP retention |
Brakes | Not included, reuses the stock JK rear rotors and calipers |
Suspension Brackets | Heavy gauge 3/16” laser cut steel brackets with multiple suspension mounting points for compatibility with lifted vehicles |
Geometry | Optimized for 4” lift kit with 5 degrees of pinion angle to reduce driveshaft angle |
Width | 65.375 inches between wheel mounting surfaces (stock JK width) |
Wheel Bolt Pattern | 5 on 5” with ½” studs installed and optional 5 on 5 1/2″ holes only |
Finish | Black satin powder coat |