Ponte anteriore rinforzato Jeep JK 07-18 Dana 60 Currie
– Facile installazione
– High Pinion con struttura centrale rinforzata
– Fuselli forgiati Currie HD
– Verniciatura speciale anti-corrosione
– 2X più resistente rispetto al Dana44 originale
– Crociere rinforzate
Il Ponte anteriore Jeep JK rinforzato Dana 60 è stato progettato per supportare pneumatici maggiorati fino alle 37″ e resistere alle prove off-road più dure al mondo.
Ponte anteriore Jeep JK rinforzato Dana 60
Ponte anteriore Jeep JK rinforzato Dana 60
SCHEDA TECNICA:
Vehicle Fitment | Currie 60 nodular Iron high-pinion radius bottom center section with thicker walls and webbing |
Pinion Bearing | Large diameter front pinion bearing matched to rear bearing |
Pinion Oiling | High volume flow-thru recirculating oil system |
Gear Set | Standard Dana 60™, compatible with super 60 reverse cut gears |
Pinion Yoke | 1350 u-joint |
Skid Plate | AR400 hardened steel |
Differential Cover | Currie nodular-iron cover with gasketed fill plug with dipstick, Red |
Axle Tubes | 3 inch diameter, .375 wall DOM tube |
Axle Bearings | Set 80 tapered roller bearing |
Axles | Currie Performance semi-floating, 40-spline (1.7” diameter) axles with JK tone rings installed for ABS and ESP retention |
Brake Rotors | Not included, reuses the stock JK rear rotors |
Brake Calipers | Not included, reuses the stock JK rear calipers |
Suspension Brackets | Heavy gauge 3/16” steel mounting brackets with multiple mounting locations that enable the suspension geometry to be tuned |
Geometry | Optimized for 4” lift kits with 5 degrees of pinion angle to reduce driveshaft angle and 5 degrees of caster for improved steering |
Width | 68.750 inches wide (between wheel mounting surfaces) |
Wheel Bolt Pattern | Dual pattern, 5 on 5” with ½” studs (installed) and 5 on 5 ½” (holes) |
Finish | Black satin powder coat |